Connect the JCI1 connector to the chassis intrusion switch/sensor on the chassis. 2. Close the chassis cover. 3. Go to BIOS > SETTINGS >Security > Chassis Intrusion Configuration. 4. Set Chassis Intrusion to Enabled. 5. Press F10 to save and exit and then press the Enter key to select Yes. 6. Once the chassis cover is opened again, a warning.. Removing the intrusion switch module: Disconnect the intrusion switch cable from the connector on the rear I/O board. Using a Phillips #2 screwdriver, loosen the screw on the intrusion switch module. Slide the intrusion switch module out of the slot on the system. NOTE:The numbers on the image do not depict the exact steps.
Chassis Intrusion Detection Switch. Switch is active when case is opened. When case is closed, the switch is depressed by the chassis panel and is made inactive. It will not affect your PC's running. The BIOS might remind you about the intrusion, but you can ignore it Reply. The chassis intrusion detection switch enables iLO to record an event in the Integrated Management Log (IML) whenever the access panel is physically opened or removed. An alert is also sent to the BIOS whenever a chassis intrusion is detected.