Mini Step Machine Fitness Air Stair Stepper Exercise Climbing Cardio

A "normal" rotation distance for a bed slinger (aka Ender 3 style) would be 40 for XY axis steppers and 8 for the Z stepper, extruder stepper is also lower than 40 usually. If you are sure it is supposed to be 360 then look somewhere else, but I would lower that number.. Klipper is a 3d-printer firmware. Contribute to Klipper3d/klipper development by creating an account on GitHub.

I also notice that Klipper seems to timeout a slower move. i.e. manual_stepper stepper=e1cam speed=90 accel=180 move=90 will need 4 times sending identical command for the motor to reach position 90. It's probably just my understanding of the command is lacking but I couldn't find much documentation and issues reported from this command.. Normally future G-Code commands will be scheduled to run after the stepper move completes, however if a manual stepper move uses SYNC=0 then future G-Code movement commands may run in parallel with the stepper movement. [mcp4018]¶ The following command is available when a mcp4018 config section is enabled. SET_DIGIPOT¶